Jump to content

Dagmar

Members
  • Posts

    2
  • Joined

  • Last visited

Dagmar's Achievements

ISF Newbie

ISF Newbie (1/5)

  1. I have a SATA connected drive. The controller would be on the motherboard, I assume? If so, no, I don't have those drivers up to date -Gigabyte has not, to this day, upgraded them to 64bit. My burner's firmware is up to date, however. Log if it helps any: (I don't have the log of when it was hanging @ "I 13:35:24 Writing LeadIn...", but I'm pretty sure it's all the same with the success log minus the parts after Writing LeadIn.) I 13:35:08 ImgBurn Version 2.5.0.0 started! I 13:35:08 Microsoft Windows 7 Ultimate x64 Edition (6.1, Build 7100) I 13:35:08 Total Physical Memory: 4,192,760 KB - Available: 3,059,096 KB I 13:35:08 Initialising SPTI... I 13:35:08 Searching for SCSI / ATAPI devices... I 13:35:09 Found 1 DVD
  2. I too have the same problem as OP. Whenever I try to burn an ISO to disc, the program hangs at "Writing LeadIn." Afterward, I call for an abort, but the program still hangs. Finally, I end up closing ImgBurn through Task Manager and while the program brute closes, the DVD drive's light (drive looks like it's reading data) is forever on until I reset my computer. The funny thing is though -after I reboot I'm able to burn the ISO into a disc. I can't figure out what is wrong. I hate to think that I have to do the above procedure just to burn an ISO into a disc. Oh yah, it was also the same way when I burned ISO to disc when I was on XP. Now it's the same deal on Windows 7.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.