I have an LG HL-DT-ST BD-RE WH16NS40 blu-ray burner with version 1.03 firmware. I am using imgburn on Linux using Crossover/Wine.
While burning a dual layer BD-RE disk, I noticed a lot of seeking near the end of layer 0. I went into the settings and (since I needed very little of layer 1 to finish the disk) set the layer break to a value equal to 75% of a layer.
Despite this, when reburning the disk, it continued on layer 0 to the same point as before, again starting to seek excessively.
It seems that the layer break setting is being ignored.
Is this supposed to work on blu-ray disks? If so, it would seem that we have a bug. If not, to avoid confusion the setting should be labeled DVD layer break.
Any help will be greatly appreciated.