Jump to content
Sign in to follow this  
icu

Coasters with 2.5.3.0 on pioneer BDR-203

Recommended Posts

I have managed to burn 3 coasters with version 2.5.3.0 on my PIONEER BD-RW BDR-203 FIRMWARE 1.10(SATA).

 

When I looked on the coasters I was amazed to see about 5-7 gaps in the burning on the media !

 

I was burning straight from an hard disk... one directory in a size of 25 GB.

 

Media used is RITEK BD-R 2x speed.

 

When I changed back to 2.5.2.0 problem disappeared, and no gaps on the media !

 

Please fix !

Share this post


Link to post
Share on other sites

People just imagine this stuff, there's no difference between the two, I haven't been near the burning code for several versions now.

 

I've done a shed load of BD burns over the past few weeks with 3 different BD drives and never had a problem.

Share this post


Link to post
Share on other sites

With all due respect m8... the 3 coasters are in the garbitch now... and I have returned to 2.5.2.0.

You can check yourself or not... but that's what realy happened.

I will wait to 2.5.4.0 before upgrading again.

Share this post


Link to post
Share on other sites

I don't have a 203 and I'm not going to buy one for a problem that doesn't exist.

 

The program just doesn't have the level of control over a burn that you obviously think it does. All I do is send data to the drive. Success / failure is down to the drive/firmware/media combo being used.

Share this post


Link to post
Share on other sites

Many thanks for the tests results.

But it was performed on the BDR-205 and not the old BDR-203.

Thanks, but I will stay with the old version which works with my drive.

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.