Jump to content

Coasters with 2.5.3.0 on pioneer BDR-203


icu

Recommended Posts

I have managed to burn 3 coasters with version 2.5.3.0 on my PIONEER BD-RW BDR-203 FIRMWARE 1.10(SATA).

 

When I looked on the coasters I was amazed to see about 5-7 gaps in the burning on the media !

 

I was burning straight from an hard disk... one directory in a size of 25 GB.

 

Media used is RITEK BD-R 2x speed.

 

When I changed back to 2.5.2.0 problem disappeared, and no gaps on the media !

 

Please fix !

Link to comment
Share on other sites

With all due respect m8... the 3 coasters are in the garbitch now... and I have returned to 2.5.2.0.

You can check yourself or not... but that's what realy happened.

I will wait to 2.5.4.0 before upgrading again.

Link to comment
Share on other sites

I don't have a 203 and I'm not going to buy one for a problem that doesn't exist.

 

The program just doesn't have the level of control over a burn that you obviously think it does. All I do is send data to the drive. Success / failure is down to the drive/firmware/media combo being used.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.