Jump to content
Yesallright

Command-line switch for auto-calculate?

Recommended Posts

Hi there,

 

I'm using Directory Opus to select files and send them directly to ImgBurn (Build mode). What I'm missing is a switch... well, title says it all! Looked a bit in the ReadMe file but couldn't find such a command. If it's not currently possible, could you please consider adding it? Thanks.

Share this post


Link to post
Share on other sites

It's enabled, but when Directory Opus sends the files, ImgBurn won't auto-calculate. I still have to press the calculator. It uses the ImgBurn toolbar with the "%PROGRAMFILES(X86)%\ImgBurn\ImgBurn.exe /MODE BUILD /SRCLIST {F|filem}" command.

Edited by Yesallright

Share this post


Link to post
Share on other sites

Ah yes, oops. There's actually code in there to stop it from auto calculating. I'm sure I put it there for a good reason at the time, so I'll leave it where it is.

 

btw, your forum email address is dead. I keep getting 'mail delivery failed' reports for the subscription emails the board is trying to send you.

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use.