Jump to content
Sign in to follow this  
sas2000

Disc Layout Editor configuration

Recommended Posts

I'd like an option to configure source window in Disc Layout Editor (Build Mode advanced input) to read only mode, so no changes can be done to files/directories of computer hard drive. Thanks.

Share this post


Link to post
Share on other sites

Hi, this feature works Ok in disc layout editor (Build mode advanced input), but when active is not possible to use drag & drop. Maybe it'd be a good idea to disable drag & drop within source/explorer panel (so no changes can be done to files/directories of computer hard drive) but allowing it from source/explorer panel to destination/burning panel. Thanks.

Edited by sas2000

Share this post


Link to post
Share on other sites

Thanks for answering, i thought it was possible because i saw this feature

on another burning software. Thanks again.

Share this post


Link to post
Share on other sites

I don't know why making that component 'read only' also stops it from being used as a drag source, I guess the code could be modified so that doesn't happen (it's open source), but there must be a reason why it behaves the way it does.

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.