Jump to content
Sign in to follow this  
burns flipper

Cannot burn DL with ImbGurn v2.0.0.0

Recommended Posts

I've been invoking ImgBurn 1.3 from PGCEdit (so I can create an ISO then immediately burn it) on Dual Layer discs with no prob. I recently installed ImgBurn 2.0.0.0 and so far it's failed and trashed the 4 DL discs I've tried to use - it fails all the 20 retries at the start, locks my drive, locks ImgBurn, and I have to reboot and bin the disc.

 

I downgraded back to v1.3 at the weekend and have so far burnt 4 DL discs without failure, all from the same stock.

 

So, I cannot burn DL discs with v2.0.0.0

 

PGCEdit already sets the layer break, and I tried burning a DL with the option not to update the IFO with the layer break, and after that created a coaster I tried it with the option on - but still got a coaster.

 

If you need any further tech info, let me know. Make sure you tell me everything you need because I'm only prepared to waste one more DL disc helping you find the bug. I have a LiteOn SOHW-1653s with the CS0T firmware patched by codeguys, and am using Traxdata 2.x DL (which work perfect with ImgBurn v1.3, I've burnt about 8 with this so far with no fails, from 2 different stocks)

Share this post


Link to post
Share on other sites

Welcome to ImgBurn Forum!

 

If you could post a log, it would help lots.

 

You might wanna go with Verbatim MKM-001s. The Traxdata are Ritek -D01s and are greatly inferior media.

 

Regards

Share this post


Link to post
Share on other sites

The burn engine between the 2 versions is identical. Lightning could probably confirm that. Burning with the new version works just fine. We'd be pretty crappy testers if we missed that small detail. :P

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.