Jump to content

New Disc should reset Image Options?


dbminter

Recommended Posts

I've noticed that if you change the Image Options in a Project and then select New Disc in Build mode, the Image Options are not changed from the last Project.  I've also noticed that if you use New Project, the previous Project's Image Options are used.

 

 

Should there be some kind of resetting of these Image Options to the default that is used when ImgBurn first loads?

Link to comment
Share on other sites

Here's what happened to me.

 

 

I have a saved ImgBurn.ibb default that loads whenever ImgBurn starts.  I know it at least sets the UDF to the highest version.  I created such a job with this Project and then created a VIDEO_TS DVD Video.  ImgBurn set the UDF to 1.02, I think it is, and whatever Image Options that need to be changed to get a VIDEO_TS compliant disc.  Then, I used Load to load ImgBurn.ibb after that to reset my options to the defaults I use on start, but the Image Options stayed at the VIDEO_TS Project options.

Link to comment
Share on other sites

It happened again!

 

 

I created a VIDEO_TS job where the Image Options were changed to UDF 1.02.  I then loaded my default Project file which sets the UDF to 2.6 or whatever the latest version is.  The Labels were reset to their blank default, but, the UDF Image Options were still set to 1.02.

Link to comment
Share on other sites

Oh, wait.  I think I figured it out.

 

 

I never apparently changed my old Set Default Options Project file.  Just my ImgBurn.ibb file.  When I load ImgBurn.ibb, it changes the UDF to what I use when I don't make a VIDEO_TS image.  But, when I loaded Set Default Options.ibb, it sets the UDF to 1.02.  I probably was alternating between loading one or the other .ibb file without realizing it.  :blush:

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.