Jump to content
Sign in to follow this  
Konstantinos88

Burn ccd, img and sub files???

Recommended Posts

I have a folder with three files: ccd, img and sub. I am going to burn them with imgburn, but I can't.

It writes in cd only the ccd file.

I run it, and I choose.the choice: "Write image file to disc".

In source - please select a file I go to the folder and I can see only ccd and img, not sub file. I choose ccd. And write speed 1x. And imgburn is burnung the cd. I choose eject tray and I am waiting.

When complete reaches 100% (and buffer and device buffer 0%) then it shows All attempts to automatically close the drive tray have failesd... and it ejects cd...

So I insert it again and I press ok. It begin again to burn. And when it finishes, it says that completed.

So, it has not burned all the files but just the files of ccd.

It is a navi program for a car. The cd rom of it does not read the cd. Any help? Thank you.

Share this post


Link to post
Share on other sites

Try with the img file. That is the actual image of the disc.

 

If you are using a laptop drive to burn the disc you have to manualy push back the tray for the verify part.

Share this post


Link to post
Share on other sites

The CCD references the IMG file and you only have to select the CCD, ImgBurn does the rest automatically.

 

ImgBurn doesn't make use of the SUB file though, you'll need to burn the CCD with CloneCD (which is what made the image in the first place) if you need accurate subchannel info (and you may well do).

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.