Jump to content

Can anybody tell me why this happened (warning error)


Mark_1955

Recommended Posts

I have a new Pioneer Burner BDR-209bdk, and this following error occurs when erasing/formatting a new BD-RE disk.

(The format disk Not Supported!)

Is it needed? or is it a setting within imgburn.  

This error does not show up using LG bd burners...

 

Thx 

Mark

 

------------------------------------------------------------

 

I 18:36:16 ImgBurn Version 2.5.8.0 started!
I 18:36:16 Microsoft Windows 7 Home Premium x64 Edition (6.1, Build 7601 : Service Pack 1)
I 18:36:16 Total Physical Memory: 4,182,632 KiB  -  Available: 2,278,808 KiB
I 18:36:16 Initialising SPTI...
I 18:36:16 Searching for SCSI / ATAPI devices...
I 18:36:17 -> Drive 1 - Info: PIONEER BD-RW   BDR-209D 1.20-ID61 (D:) (ATA)
I 18:36:17 Found 1 BD-RE!
I 18:36:48 Operation Started!
I 18:36:48 Device: [2:0:0] PIONEER BD-RW   BDR-209D 1.20 (D:) (ATA)
I 18:36:48 Media Type: BD-RE (Disc ID: VERBAT-IM0-000)
I 18:36:48 Media Supported Write Speeds: 2x
I 18:36:48 Quick Erase: No
I 18:36:48 Format Properly: Yes
I 18:36:48 Format Size: Preferred
I 18:36:48 Format With Full Certification: Yes
I 18:36:48 Format Without Spare Areas: Yes
I 18:36:48 Erasing Disc...
W 18:36:48 FormatDisc(FT: 0x31, FST: 0x02) Not Supported!
W 18:36:48 FormatDisc(FT: 0x31, FST: 0x03) Not Supported!
I 18:37:11 Operation Successfully Completed! - Duration: 00:00:22
I 18:37:11 Operation Started!
I 18:37:11 Device: [2:0:0] PIONEER BD-RW   BDR-209D 1.20 (D:) (ATA)
I 18:37:11 Media Type: BD-RE (Disc ID: VERBAT-IM0-000)
I 18:37:11 Media Supported Write Speeds: 2x
I 18:37:11 Media Sectors: 12,219,392
I 18:37:11 BD-RE FastWrite: No
I 18:37:11 Zeroing Sectors...
I 19:23:57 Synchronising Cache...
I 19:23:57 Operation Successfully Completed! - Duration: 00:46:46 - Total Duration: 00:47:09
I 19:23:57 Average Write Rate: 8,709 KiB/s (2.0x)
 
-----------------------------------------------------------------------------
Edited by Mark_1955
Link to comment
Share on other sites

I'm still a bit confused.  My Pioneer returns the same "warning" but a first format takes 45 minutes and not 20 seconds.  Are you saying a certification support would increase the formatting time by an hour in addition to the 45 minutes it takes to first format a BD-RE in my Pioneer?

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.