korz Posted April 26, 2015 Share Posted April 26, 2015 I just opened a new package of JVC (Taiyo Yuden) blu-ray disks (BD-R) and tried to burn some jpgs onto it with the latest version of ImgBurn on my LG GGW-H20L drive. I got the following error, early in the burn: I/O Error!Device: [0:4:0] HL-DT-ST-BD-RE GGW-H20L YL05 (E:) (ATAPI)ScsiStatus: 0x02Interpretation: Check ConditionCDB: AA 00 00 00 00 60 00 00 00 20 40 00Interpretation: Write(12)-Sectors:96-127Sense Area: 71 00 03 00 00 00 00 0A 37 2D 03 B4 0C 00 00 00 00 00SK Interpretation: Medium ErrorASC/ASCQ Interpretation: Write Error After I exited, I noticed that I had it set to 10X burn speed. What's the likely reason for the failure? Is it the burn speed? Is it that I need new firmware for my drive? Is it just bad luck? I want to sort this out before I make more expensive coasters, but I would prefer to not update the firmware if it's not necessary. Thanks. Link to comment Share on other sites More sharing options...
korz Posted April 26, 2015 Author Share Posted April 26, 2015 Nevermind. I just remembered that I need to include the log. When I looked at the log to paste it here, I found that it says that I tried to burn at 10x, but the drive only supports 2x. Duh! Thanks for a great product! I have donated to help support it. Everyone should. Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted April 26, 2015 Share Posted April 26, 2015 Go for the firmware update. Those jvc discs are probably the cheaper LTH ones too. They aren't as good as the normal HTL ones. Link to comment Share on other sites More sharing options...
Recommended Posts