Jump to content
mindstain75

Stuck searching for SCSI / ATAPI devices

Recommended Posts

I 01:11:50 ImgBurn Version 2.5.8.0 started!
I 01:11:50 Microsoft Windows 8 Professional x64 Edition (6.2, Build 9200)
I 01:11:50 Total Physical Memory: 8,336,292 KiB  -  Available: 6,005,096 KiB
I 01:11:50 Initialising SPTI...
I 01:11:50 Searching for SCSI / ATAPI devices...
 

I do have a pretty old computer, but I rolled back my drivers and then updated them back to current. Not sure what I should try next.

Share this post


Link to post
Share on other sites

Try changing your Interface and see if that helps.  It's currently set at SPTI.  Under Tools, under Settings, under I/O, on Page 1, there's an Interface listing.  SPTI should be selected.  Try the other options and see if you get any better results.  You may need to exit and restart ImgBurn after each change, I'm not sure.  If this doesn't help, change the setting back to its default of SPTI.  Other than that, LUK will have to cover it as I'm tapped out.

Share this post


Link to post
Share on other sites

Yes, check the FAQ; I just did.  :D  It will tell you how to enable Debug Mode and copy and paste the appropriate log section so LUK can debug it.

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use.