KBS Posted August 13 My direct show filter add on to burn flac files installs fine says it's registered to work but imageburn doesn't see it to analyze the files any suggestions. Share this post Link to post Share on other sites
dbminter Posted August 13 I use madFLAC to process FLAC files in ImgBurn. You're welcome to try installing that if you can't get Direct Show filters to work. Had you ever gotten them to work before and they suddenly stopped? Share this post Link to post Share on other sites
KBS Posted August 13 (edited) That is what I installed was madFlac image-burn doesn't see it even when it says successfully installed.This is first time I've dealt with Flac files. Edited August 13 by KBS Share this post Link to post Share on other sites
LIGHTNING UK! Posted August 14 ImgBurn doesn’t see the filters, your system does. Once they’re properly known/installed, directshow will use them. Of course it could always be that your flac files aren’t supported by madFlac. Share this post Link to post Share on other sites
kxkvi Posted August 20 (edited) On 8/13/2019 at 1:37 PM, KBS said: That is what I installed was madFlac image-burn doesn't see it even when it says successfully installed. You didn't happen to delete/move the source files after installation, did you? By source files, I mean the madflac.ax and libflac.dll. Regards, Thomas Edited August 20 by kxkvi Additional info for disambiguation. Share this post Link to post Share on other sites