Jump to content
KBS

Direct Show Filter

Recommended Posts

My direct show filter add on to burn flac files installs fine says it's registered to work but imageburn doesn't see it to analyze the files any suggestions.

Share this post


Link to post
Share on other sites

I use madFLAC to process FLAC files in ImgBurn.  You're welcome to try installing that if you can't get Direct Show filters to work.  Had you ever gotten them to work before and they suddenly stopped?

Share this post


Link to post
Share on other sites
Posted (edited)

That is what I installed was madFlac image-burn doesn't see it even when it says successfully installed.This is first time I've dealt with Flac files.

 

 

Edited by KBS

Share this post


Link to post
Share on other sites

ImgBurn doesn’t see the filters, your system does.

Once they’re properly known/installed, directshow will use them.

Of course it could always be that your flac files aren’t supported by madFlac.

Share this post


Link to post
Share on other sites
On 8/13/2019 at 1:37 PM, KBS said:

That is what I installed was madFlac image-burn doesn't see it even when it says successfully installed.

 

You didn't happen to delete/move the source files after installation, did you?  By source files, I mean the madflac.ax and libflac.dll.

Regards,

Thomas

Edited by kxkvi
Additional info for disambiguation.

Share this post


Link to post
Share on other sites

×

Important Information

By using this site, you agree to our Terms of Use.