Jump to content

Problems burning in Vista


TLM

Recommended Posts

About the only thing I remember from CloneCD is that is reads / writes 16 sectors at a time where I default to 32 if the driver says it supports it.

 

Try changing the 'I/O Transfer Length' option in ImgBurn to 'Manual' and '32K'.

 

Other than that (especially if you're using ElbyCDIO as the I/O Interface) there's no reason for it to just stop like that.

 

As I've proved, this is not a general problem with the program because on my machine, that OS / drive / media combo works fine.

 

If you really wanted to know where it was dying you'd need a bus sniffing tool. I believe you can find a free one on the net for capturing SPTI calls.

Link to comment
Share on other sites

If you really wanted to know where it was dying you'd need a bus sniffing tool. I believe you can find a free one on the net for capturing SPTI calls.

 

Would you be able to interpret the logs from that? I'm sure I'll not be able to make any sense of them. :)

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.