Jump to content
Sign in to follow this  
OneEyedMan

Problem when BUILDTYPE in CLI not same as in IBB

Recommended Posts

Hi Lightning UK,

 

First of, you have created a perfect burn prog! Especially the CLI mode is great!

I have succeeded in using the prog for several disks now, and did not have a single failure.

However, I wanted to use an IBB file as input, and sent the output directly to a device, using the CLI. I saved a default project,

and then used the commandline to start ImgBurn:

ImgBurn.exe /MODE ISOBUILD /BUILDMODE DEVICE /SRC "d:\Images\test.ibb" /DEST h: /ROOTFOLDER NO /NOIMAGEDETAILS

This caused ImgBurn to start with a message "Terminating interface thread", and it had to be killed with the taskmanager.

If I delete the line: BuildMode=2 or use BuildMode=1 the program runs just fine.

 

Not an urgent bug (for me) just thought to report it

 

Luck!

 

OneEyedman

Share this post


Link to post
Share on other sites

This is all linked in with some other CLI issues where the mode is switched whilst the program is already busy in a thread. (Those issues already exist as bug reports)

 

I believe I have fixed the issue in the beta I'm currently working on and it will of course be available whenever the next 'final' release is made to the public.

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.