Jump to content

write speed settings


chewy

Recommended Posts

I was doing some testing of Imgburn with some Sony/MIJ/Yud T02's and my new NEC 3550A.

I first overspeeded a burn at 16x, then changed write speed to 12x and burned another disk,

my cdspeed scans with my Benq 1620 were disappointing, this media has tested the best at 8x

burn speed, consistent 97-99QS. I repeated at 12x, same result. My only clues are burn times being too

low for the indicated speed. 7:04 @12x 4400MB iso

 

The three disks hit the garbage

 

QS 30-64 rogue spikes

 

baseline 8xburn attached

Link to comment
Share on other sites

Unlikey, software plays no part in the burn quality - unless it's turning on/off special drive features - which ImgBurn doesn't touch.

 

Why don't you use the 'Graph' feature in ImgBurn to see how it thinks the burn went. It may at least show you where the drive was slowing itself down.

Link to comment
Share on other sites

thanks LUK,

It's looking to be an inconsistentcy between blanks issue, after reburning another

at 12x w/ImgBurn and scanning I got an acceptable burn. Unless there is something

to the notion that burners learn to burn? These were the first burns at 12x w/ this burner.

Pardon my ignorance, I came here to learn.

 

Might crosscheck with my LG4136B next, my other top burner.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.