Jump to content
Sign in to follow this  
cornholio7

How to write DVD Video files directly to single layer media using ImgBurn

Recommended Posts

This guide will cover converting a full set of Vob, Ifo and Bup files on your Hard Drive to Single Layer Media.

 

We recommend only Verbatim and Taiyo Yuden Discs

 

Firstly make sure your Vob, Ifo and Bup files are in a folder called VIDEO_TS. This makes the whole process slightly simpler.

 

Open ImgBurn and switch to Build mode. (In the menu at the top, click 'Mode' -> 'Build')

 

post-8-1186858718_thumb.png

 

Ensure it's set to output to Device. (In the menu at the top, click 'Output' -> 'Device')

 

post-8-1186858724_thumb.png

 

Alternatively, click on the button shown below to switch the 'Output' between 'Image File' and 'Device'. (Please Note: The picture shown below is what you'd see when the 'Output' is already set to 'Device')

 

post-8-1186861938_thumb.png

 

Click the 'Browse for a folder...' button in the 'Source' box and navigate to the folder where your files are stored. Select the folder and click on the 'OK' button.

 

post-8-1186856222_thumb.png

 

post-1-1186937288_thumb.png

 

Press the 'Calculate' button to make sure your project will fit on Single Layer media.

 

post-8-1186856238_thumb.png

 

The 'Min. Req. Media' text should match what you're trying to burn onto. As this is the 'single layer' guide, it should read something like 'DVD+-R/RW'.

 

post-8-1186869418_thumb.png

 

Switch to the 'Device' tab and you'll be able to select your desired 'Write Speed' for the disc. (See more on this here)

Whilst here, if you're using DVD+R media, know what you're doing and your drive support it, you can mess around with the booktype settings so that your drive makes the burnt disc look like a DVD-ROM. This can improve the compatibility with certain players.

 

post-8-1186856258_thumb.png

 

Now go to the 'Options' tab, choose ISO9660+UDF in the 'File System' drop down box.

 

post-8-1186856266_thumb.png

 

Then go to the 'Labels' tab and enter the label in both fields (you can click on the icon shown to copy the label from one field to all the others)

 

post-8-1186856274_thumb.png

 

Then when you're all done playing with the settings, press the 'Build' button to get things started.

 

post-8-1186856281_thumb.png

 

The Information box will then pop up telling you some details about what's about to get burnt to the disc.

 

Press 'Ok' and it will start writing the Disc.

 

post-8-1186937745_thumb.png

 

Then sit back and relax whilst your Disc is burning.

 

post-8-1186856297_thumb.png

 

It will be dependent on your drive, media and firmware as to how long the burn and verify will take.

 

post-8-1186857006_thumb.png

 

THE END!

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.