renshaw8 Posted October 12, 2008 Share Posted October 12, 2008 I keep having failure burns. Can anyone tell me if this "Close request Acknowledged" report in my Imgburn log is normal or is something telling my burn to shut down? Thanks Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted October 12, 2008 Share Posted October 12, 2008 That goes in the log when YOU close the program. It's just so quick that you don't notice it in the log window. Link to comment Share on other sites More sharing options...
renshaw8 Posted October 12, 2008 Author Share Posted October 12, 2008 Thanks Lightning, That's just the thing. I don't close the program. That is what my log says after a bad burn. About 7 in a row now. I've only been getting about 9% if anything before it quits and I get an I/O error message. What would be telling ImgBurn to close? Link to comment Share on other sites More sharing options...
mmalves Posted October 12, 2008 Share Posted October 12, 2008 Please post the log of the failed burn (it'll have 'Operation Started!' lines and a lot more info that we can use). Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted October 12, 2008 Share Posted October 12, 2008 The ones you're showing are just when you open and close the program without doing anything. If you're burning via something else (i.e. DVD Flick) the log will probably be missing those sessions because they're local to that application. Link to comment Share on other sites More sharing options...
renshaw8 Posted October 12, 2008 Author Share Posted October 12, 2008 I just had a successful burn with a Maxell DVD+RW disk and so again I tried a Sony DVD+R disk and again it was unsuccessful. Heres the ImgBurn log. imgburn.log Link to comment Share on other sites More sharing options...
mmalves Posted October 12, 2008 Share Posted October 12, 2008 I 15:31:30 Destination Device: [1:0:0] MATSHITA DVD-RAM UJ-841S 1.60 (D:) (ATA)I 15:31:30 Destination Media Type: DVD-R (Disc ID: RITEKF1) (Speeds: 1x, 2x, 4x, 6x, 8x) I 15:31:30 Write Speed: 4x W 15:31:44 Failed to Write Sectors 0 - 31 - Reason: Power Calibration Area Error Try burning at the other available speeds to see if works. If it doesn't, get Verbatim or Taiyo Yuden blanks and it should work fine Link to comment Share on other sites More sharing options...
renshaw8 Posted October 13, 2008 Author Share Posted October 13, 2008 OK Thanks mmalves Link to comment Share on other sites More sharing options...
Recommended Posts