Avatar1301

1. Yeah I did, and the same problem 2. You know an easy way to clean a drive, without a "clean-disk" or whatever it's called? 3. I'm afraid so, but eventually it might be the only solution. I'm going to try to remove the drive from the computers disk/device management menu, and then remove it physicallly. And then try to put it in the PC again. Thx for the help peepz

chill out spinningwheel I'm not trying to be a "know-it-all" and I like ImgBurn. I just don't like Verbatim and the reputation it has, 'cause it's just as good as many others. You have a good time using Verbatim. I'm having a good time using BulkPaq. So please help me, but don't say anything about the media, but point out something else. And if I'm out of luck, I can just buy a new burner, if it comes to it. In any way, that will allways be cheaper, than to buy Verbatim

No it is't a good burn, because it haven't even started to burn yet... And I have tried with a Verbatim now. The same error happens... Sry Verbatim fanboys

no I don't... BulqPack is just as good as Verbatim. Some of you just haven't figured it out yet. Sorry to say it And for your information, iv'e never ever had a single bad burn with BulqPack...

I get the error: "Set L0 Data Zone Capacity Failed! - Reason: Power Calibration Area Error" when I try to burn Iv'e done this a lot of times and Iv'e tried to update to the latest firmware. Without luck... Here's the log: I 22:30:47 ImgBurn Version 2.4.4.0 started! I 22:30:47 Microsoft Windows Vista Ultimate Edition (6.0, Build 6001 : Service Pack 1) I 22:30:47 Total Physical Memory: 3.143.944 KB - Available: 1.475.976 KB W 22:30:47 Drive L:\ (FAT32) does not support single files > 4 GB in size. I 22:30:47 Initialising SPTI... I 22:30:47 Searching for SCSI / ATAPI devices... I 22:30:47 Found 2 DVD