Jump to content

Device not ready (unable to recover toc)


Spawn

Recommended Posts

I 23:12:49 ImgBurn Version 2.4.4.0 started!

I 23:12:49 Microsoft Windows XP Media Center Edition (5.1, Build 2600 : Service Pack 2)

I 23:12:49 Total Physical Memory: 1,046,704 KB - Available: 630,852 KB

I 23:12:49 Initialising SPTI...

I 23:12:49 Searching for SCSI / ATAPI devices...

I 23:12:49 Found 1 DVD

Edited by Spawn
Link to comment
Share on other sites

Does it recognize other DVD discs? e.g. ImgBurn shows "Ready (Disc Not Empty)" in the status bar.

 

If it does, please copy all the text shown in the Information box on the right-side of ImgBurn's window.

Link to comment
Share on other sites

This is what it says when I put in a dvd movie (in this case V for Vendetta also it said disk not empty):

 

TSSTcorp CD/DVDW TS-L532M HR08 (ATA)

Current Profile: DVD-ROM

 

Disc Information:

Status: Complete

Erasable: No

Sessions: 1

Sectors: 3,771,763

Size: 7,724,570,624 bytes

Time: 838:12:13 (MM:SS:FF)

 

TOC Information:

Session 1... (LBA: 0)

-> Track 01 (Mode 1, LBA: 0 - 3771762)

-> LeadOut (LBA: 3771763)

 

Physical Format Information (Last Recorded):

Book Type: DVD-ROM

Part Version: 1

Disc Size: 120mm

Maximum Read Rate: 10.08Mbps

Number of Layers: 2

Track Path: Opposite Track Path (OTP)

Linear Density: 0.293 um/bit

Track Density: 0.74 um/track

First Physical Sector of Data Area: 196,608

Last Physical Sector of Data Area: 16,580,594

Last Physical Sector in Layer 0: 2,082,495

 

Layer Information:

Layer 0 Sectors: 1,885,888 (50%)

Layer 1 Sectors: 1,885,875 (50%)

Link to comment
Share on other sites

Either the discs are totally shot or the drive/drive controller is. But, since the drive can read original DVDs, well, it may just be the discs. Try to put one of those discs in another machine with ImgBurn on it and see what it says (i.e. if it can give full disc info).

 

Regards

Link to comment
Share on other sites

I used a few of the disks I had before to burn things on the computer I'm using now and it worked fine/has been working fine. The error just came up today before I updated the program, I figured if I updated it, the program would fix itself. :-/

 

I'll give what you said a shot later today though.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.