ImgBurn burns successfully but player gives disc error

[--RS]

I built a DVD from files and ImgBurn produced no errors! But the player states disk error! And even the PC cannot read the DVD at all now! What's happening?

 

Here's the log:

I 00:06:44 ImgBurn Version 2.4.4.0 started!

I 00:06:44 Microsoft Windows XP Media Center Edition (5.1, Build 2600 : Service Pack 3)

I 00:06:44 Total Physical Memory: 1,834,476 KB - Available: 870,760 KB

W 00:06:44 Drive D:\ (FAT32) does not support single files > 4 GB in size.

W 00:06:44 Drive K:\ (FAT32) does not support single files > 4 GB in size.

I 00:06:44 Initialising SPTI...

I 00:06:44 Searching for SCSI / ATAPI devices...

I 00:06:45 Found 1 DVD-ROM and 1 DVD

[mmalves]

It's a good burn, so if there's an error it's in the source files. Have you tried playing the disc with MPC-HC or VLC Media Player? PowerDVD/WinDVD also can be used if you have them.

 

By the way...

I 00:10:16 Destination Device: [0:0:0] PIONEER DVD-RW DVR-115D 1.13 (E:) (ATA)

There's newer firmware available for your burner (remove any disc and close the tray before updating then reboot after it's finished).

[--RS]

It's a good burn, so if there's an error it's in the source files. Have you tried playing the disc with MPC-HC or VLC Media Player? PowerDVD/WinDVD also can be used if you have them.

 

By the way...

I 00:10:16 Destination Device: [0:0:0] PIONEER DVD-RW DVR-115D 1.13 (E:) (ATA)

There's newer firmware available for your burner (remove any disc and close the tray before updating then reboot after it's finished).

It is my DVD player, LG DVD5195, that has finally died!!!! It gives 'disc error' on _all_ DVDs!

[Cynthia]

Try to run a disc cleaner product that cleans the laser head.