Race Guy Posted July 7, 2009 Share Posted July 7, 2009 If I build an image directly to the drive using a "virgin" BD-RE, the steps on my end are: 1) Format disc (which takes about 1h20min) 2) Zeroing sectors (which takes about 40min) 3) The image build/write starts, the "label" box opens & you have 30 seconds to alter the label or it's auto accepted. 4) A confirmation box opens that shows the image "specs" & you can OK or Cancel. It's "frozen" there till you pick. Could you eliminate (or make switchable) the "30 second timeout" on the label box. I usually want to alter the label, but if I'm not there to catch that 30 second window, there's no way to back up to it other than canceling the whole thing out. Since we freeze on the next step, why not freeze on the labeling step? Thanks! Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted July 7, 2009 Share Posted July 7, 2009 Did you even look in the Settings?! Build tab, 'Volume Label - Auto 'Yes''. Link to comment Share on other sites More sharing options...
Race Guy Posted July 7, 2009 Author Share Posted July 7, 2009 I KNEW you might say something like that LUK! I was building/writing an RE when I asked, so I couldn't look at the settings for at LEAST another hour & a half. See ya! Link to comment Share on other sites More sharing options...
Recommended Posts