Jump to content

Robot and Media Changer help


Sizzlechest

Recommended Posts

I saw the new options in 2.5.1.0 for robots and media changers, so I thought I'd try it out with my Primera Bravo II Disc Publisher. I enabled the checkboxes in the I/O section, but I got the following errors:

 

I 10:08:08 Initialising BS_Robots...

E 10:08:08 Unable to initialise BS_Robots! - BSRobots20.dll

E 10:08:08 Reason: The specified module could not be found.

I 10:08:09 Initialising SPTI...

I 10:08:09 Searching for Auto Loader devices...

I 10:08:09 Found 0 Auto Loaders!

I 10:08:09 Searching for Medium Changer devices...

I 10:08:09 Found 0 Medium Changers!

I 10:08:09 Searching for SCSI / ATAPI devices...

I 10:08:09 -> Drive 1 - Info: HL-DT-ST CD-ROM GCR-8480B 1.00 (D:) (ATA)

I 10:08:09 -> Drive 2 - Info: PIONEER DVD-RW DVR-108 9.18 (E:) (USB)

I 10:08:09 Found 1 CD-ROM and 1 DVD±RW!

 

FYI, the Pioneer is the drive in the duplicator.

 

Where do I get the BSRobots20.dll file?

Link to comment
Share on other sites

Can I ask, does ImgBurn have direct access to the drive that's in the robotic unit?

 

If it's just a case of me telling the robot to load/eject a disc, it should be pretty easy to add support for it.

 

Yes. All burning software has access to the Pioneer drive. I can burn discs, open the tray, and close the tray just fine, but the robot doesn't load/unload or print, obviously.

Link to comment
Share on other sites

Hmm ok, I'll see if I can get the SDK off them that lets me move the robot around.

 

If you hang around for a while, and assuming you're interested/don't mind, I could use you for the testing - as I don't have such a unit here myself :)

 

Sure. No problem. I'll be you guinea pig. :D

Link to comment
Share on other sites

Cool, I've filled out the form to request the password to their SDK.

 

I don't suppose you've got the unit on a PC that could be accessed via remote desktop / vnc?!

 

I'm thinking it might be nightmare trying to do it semi blind.

 

Acronova sent me a unit when they asked me to do it for their Nimbie product.

Link to comment
Share on other sites

Cool, I've filled out the form to request the password to their SDK.

 

I don't suppose you've got the unit on a PC that could be accessed via remote desktop / vnc?!

 

I'm thinking it might be nightmare trying to do it semi blind.

 

Acronova sent me a unit when they asked me to do it for their Nimbie product.

 

 

I would if I could, but it's on a PC that's not accessible from Internet.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.