Jump to content

On Startup bug?


Wheelie4

Recommended Posts

This is in no way a problem for me so I'm not complaining. Just posting an observation. I know that majority of the time I will build (on-the-fly) to device. So in Settings>Event tab>On Startup I set:

 

Set Program Mode: Build

Set Build Mode: Device

and clicked OK

 

But no matter what output mode I leave Imgburn in (image mode or device mode) when I exit. When I reopen Imgburn it's still in the last output mode it was in when exiting. If I exit with it in image mode, when I open Imgburn again it's still in image mode. BTW I did a clean install and rebooted after uninstalling v1.3 and rebooting. Wasn't sure it was a bug so I posted here.

 

Aside from that, thank you so much lightningUK for this build mode. :thumbup:

Edited by Wheelie4
Link to comment
Share on other sites

personally i wouldnt have bothered.

i leave the lights on on my car when i go in the shop , i switch the car off and the lights go off, when i get back in and turn the engine on, the lights come back on

 

what if the next time you want to start IB you want to use build mode again ? at least its in the mode i want and i dont have to change mode ! 6 of one half a dozen of the other really

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.