Jump to content

Build mode - Last selected tab is not remembered between sessions


Recommended Posts

When IB starts in Build Mode it always defaults to the Information tab. Can you make it save the last selected tab (and sub-tab in the case when the Advanced tab is selected) so that it's remembered when IB is next started.

 

Reason being that most of the burns I do have the same prefs apart from the Volume Label.

Link to comment
Share on other sites

A 'Remember MRU Tab' option has now been added to the settings on the 'Build' tab for this.

 

btw, as you'll see from going mode to mode, the tabs were actually reset on purpose (so it always went back to the information one), rather than it just not remember what you were on.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.