silentwun Posted November 17, 2013 Share Posted November 17, 2013 Hi. I cannot burn single or dual layer dvds. I haven't tried cds yet. On dual layers it won't go pass 20% while burning. Single layer disc have errors at the beginning. Tried different drives to see if I had a bad drive but the problems are the same. ImgBurn.log Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted November 17, 2013 Share Posted November 17, 2013 What controller is the drive attached to? It's not working well with your optical drives. Link to comment Share on other sites More sharing options...
silentwun Posted November 18, 2013 Author Share Posted November 18, 2013 via vt6421 Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted November 18, 2013 Share Posted November 18, 2013 They might be ok for certain flashing related purposes but should be avoided at all other times. Connect it to the main controller on your motherboard. Oh and you should only enable overspeed when using mkm-001-00 media. Link to comment Share on other sites More sharing options...
silentwun Posted November 20, 2013 Author Share Posted November 20, 2013 My pc doesn't have an onboard controller for sata. So I had to use a pci card. Should I purchase a better card or a new pc is in order? Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted November 20, 2013 Share Posted November 20, 2013 Get a card using the silicon image chipset if you want to go that route - a 3512 or similar. It'll be cheaper than a new PC. You should find them on eBay without too much trouble. Link to comment Share on other sites More sharing options...
silentwun Posted November 28, 2013 Author Share Posted November 28, 2013 (edited) I installed fresh OS and the SIL3512 card. So far so good. Two consecutive burns back to back. Thank you. Edited November 28, 2013 by silentwun Link to comment Share on other sites More sharing options...
Recommended Posts