Jump to content

Found an ISO build bug with command line


JasonFriday13

Recommended Posts

Loading an .ibb file as the SRC, D: as the DEST, the MODE set to ISOBUILD, the BUILDMODE set to DEVICE on the command line, while passing the /START switch, causes ImgBurn to hang showing "Terminating Interface Thread". I am sure this is a bug. The same line except building an iso works fine.

Link to comment
Share on other sites

Thanks, I know about the IBB problem.

 

It's because it tries to change drives whilst it's busy doing something else and it hits deadlock.

 

If the IBB specifies the same drives as the currently active one it shouldn't be an issue.

 

This problem isn't limited to the command line either :) (or rather :( )

Link to comment
Share on other sites

Ah well, either way!

 

It has been on my todo list for a few weeks now but I hope to actually start fixing it today.

 

Oh and as the IBB is loaded after the CLI /DEST argument comes into play, the IBB ones take preference (*if specified).

Link to comment
Share on other sites

  • 7 months later...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.