Hello,
I have had the issue occasionally over the years and I think I discovered the common thread. I always have "verify" selected when I burn a data DVD. I use a laptop so the tray does not close when attempting to cycle between write and verify. If I close the drive tray and wait 20 seconds then the verify always starts successfully and the disc can be read on the laptop after completed. However, if I close the tray and tell Imgburn to start the verify before the disc drive is 100% quiet, then the verify fails to start or gives an error. Also then the laptop refuses to recognize the disc as having data even after restarting the computer and reinstalling drivers for the disk drive. However the disc will almost always (at least 7 out of 10 times) load on my other 2 computers. I am sure the burn is always successful but why won't the data be recognized on this computer, Is the burn not finalized before verifying? I know that I can do the verify as a separate task after, I do not need to select the verify to start immediately after burn and perhaps that's the best way but then I risk forgetting to verify. What is happening? Thank you so much or any enlightenment.