Jump to content

Skip power calibration area test??


nickba

Recommended Posts

Hi,

 

I bought some DVD+R DL last week and I am receiving this error: "power calibration area is full."

This error appears after about 3 minutes after I insert the disc.

 

But the most interesting thing is that if I choose to continue after the error, imgburn burns and verifies the disc OK!!!! And the disc works fine.

 

So is there a way to skip or disable the calibration area test? This way I will not have to wait 3 minutes with the drive trying to calibrate and give me the error.

 

 

 

 

Link to comment
Share on other sites

Related to this subject in similar threads, it is suggested that the media could be the issue, burner firmware may need updating or the burner may be on it's last leg.  Try burning at a different supported speed, clean the laser, try a better quality brand of disc.

Link to comment
Share on other sites

Related to this subject in similar threads, it is suggested that the media could be the issue, burner firmware may need updating or the burner may be on it's last leg.  Try burning at a different supported speed, clean the laser, try a better quality brand of disc.

 

 

:yes:

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.