Jump to content

Burning an ISO


wishfull

Recommended Posts

Q: How can I force IB to burn the first layer on a DL full(most) and the remaining on the second layer?

 

Before burning a vid/data disc I make an ISO first after removing the locks when necessary. For burn convenience only.

 

Burning an ISO about 7gb on a DL , the data is auto splitted by IB almost exactly in the half.

3.5gb on first layer and 3.5gb on the second.

 

Have done some experiments and reading in manuals but unable to succeed or find any other usefull info, exept for a new build.

 

Any advice welcome.

Link to comment
Share on other sites

You can pick the cell that is most "warped" in the layer break dialogue. Or split the cells after the ones offered with VobBlanker or DVDRMP to enable a bigger choice of cells at which to break.

 

There are some benefits of writing more on layer 0 - for one the PIE/PIFs on L0 are usually much less than those on L1. However, these can be, and often are, outweighed by the risks of writing too close to the edge of the disk. As well, the write time will increase as L1 is padded out.

 

Regards

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.