Jump to content

ImgBurn or hardware problem?


DjKilla

Recommended Posts

Recently I started getting the following message. Is this a hardware or ImgBurn problem/issue?

 

1.jpg

 

I 11:54:38 ImgBurn Version 2.4.1.0 started!

I 11:54:38 Microsoft Windows XP Home Edition (5.1, Build 2600 : Service Pack 2)

I 11:54:38 Total Physical Memory: 523,568 KB - Available: 328,536 KB

I 11:54:38 Initialising SPTI...

I 11:54:38 Searching for SCSI / ATAPI devices...

I 11:54:38 Found 1 DVD-ROM and 1 DVD

Edited by DjKilla
Link to comment
Share on other sites

It's always hardware or media issue.

 

clean the drive with cd cleaner

 

update to latest firmware (I think 1.24 is latest though)

 

try OPC yes in write settings

 

how many ty's have done that are they FAKE or genuine.

 

I have the latest firmware and use genuine Taiyo Yuden 16x media from rima.com. I never had an issue until I received my latest batch of Taiyo Yuden 16x DVD-R media from rima. I'm not sure if it's the media or the drive. I've been ordering for years from rima but never had an issue.

 

As for OPC, I see a box that says 'Perform OPC Before Write' under the *write* tab in settings. Is this the box I need to check?

 

I've always used the latest version of ImgBurn without any problems. Is this because OPC was always on/checked in previous versions of ImgBurn and the current version has it off/unchecked which could be causing the problems I'm having?

Edited by DjKilla
Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.