Jump to content

Setup screen freezes when trying to reformat


jmet

Recommended Posts

I change the BIOS to boot from CD. Upon rebooting, my BIOS hangs for about 60 seconds, then proceeds to load. When it says press any key to boot from CD, I then press a key. It then goes to a black screen that says "Setup is inspecting your configuration" (or something close to that). It never loads. or I just didn't wait long enough. I waited for like 10 min. There is no activity light blinking either.

 

What could be wrong?

Link to comment
Share on other sites

Well, the problem was a bad stick of RAM. Removed it then tried it again and it went as smooth as pie. :)

 

Did you try just reseating the memory module JMet?

 

It might still be good just got jarred loose.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.