Jump to content

How to write DVD Video files directly to double layer media using ImgBurn


cornholio7

Recommended Posts

This will cover a full set of Vob, Ifo and Bup files on your Hard Drive to Dual Layer Media.

 

We recommend only Verbatim +R DL discs. See why here

 

It is NOT recommended to use DVD-R DL Discs for Video.

 

Firstly make sure your Vob, Ifo and Bup files are in a folder called VIDEO_TS

 

then open ImgBurn in Build Mode and ensure it's set to output to Device (In the menu at the top, click 'Mode' -> 'Build', then click 'Output' -> 'Device')

 

then choose the folder option in the source box, and navigate to the folder you stored the files.

 

post-8-1150476658_thumb.png

 

post-8-1153595887_thumb.png

 

Press the calculator to make sure your project will fit on Dual Layer media.

 

post-8-1153596402_thumb.png

 

At this point you will see a similar window to the one shown below.

 

post-8-1153596453_thumb.png

 

This is where you decide which bit of the film should be the first bit after the layer jump (where the player may pause for a second as the laser moves from layer 1 to layer 2).

 

You might get one option here or you could get several. If there's only one, it's obvious which one you need to select! If there's more than one, select the one with the best rating - look at the stars!

 

In this example, the best option is the one with the blue star that says 'No' in the SPLIP column.

 

Make your selection and then press 'Ok'.

 

Choose your write speed in 'Device'.

Whilst here, you can make sure your drive has bit setting set to DVD-ROM for Dual Layer media. (if your drive supports it)

 

post-8-1153595930_thumb.png

 

At this point go to the Options tab, choose ISO9660+UDF .

 

post-8-1153595988_thumb.png

 

Then go to the Labels tab and enter the label in both fields

 

post-8-1153596074_thumb.png

 

 

post-8-1153596543_thumb.png

 

Then press the build button (Highlighted in the red box) and you will see a similar layer break window again,

 

post-8-1154550333_thumb.png

 

Normally you shouldn't worry about ticking the 'Don't update IFO/BUP files' box, and you should definintely not tick it unless you have prepared IFO's in advance containing layer break info.

 

Press 'Ok'

 

You will then see this window.

 

post-8-1153597072_thumb.png

 

Press 'Ok' and the programme will start writing the Disc.

 

post-8-1150477132_thumb.png

 

Then sit back and relax whilst your Disc is burning.

 

post-8-1150477220_thumb.png

 

It will be dependent on your drive, media and firmware as to how long the burn and verify will take.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.