Jump to content

forced write speeds?


yikes
 Share

Recommended Posts

hello

 

i just replaced my failing pio 116D with a plex px-870A. these are both IDE drives. out of habbit ive alway burned certain things @ 4x. since changing over to the plex ive noticed it does not burn anything slower than 6x no matter if its +R or -R ( at least with imageburn...have not check other burn sw). although i dont think burning things @6x as opposed to 4x would make much of a differnce....is there a way to force it to burn @4x or is this hard coded into the plex firmware and nothing can be done about it?

 

thanks

Edited by yikes
Link to comment
Share on other sites

Look at the ImgBurn log for your burns and see what speeds you can burn your media at, or post a log and we'll tell you.

 

 

are you referring to this :

 

 

I 17:01:11 Source File File System(s): Special

I 17:01:11 Destination Device: [2:0:0] PLEXTOR DVDR PX-870A 1.05 (Y:) (ATA)

I 17:01:11 Destination Media Type: DVD-R (Disc ID: CMC MAG. AM3) (Speeds: 6x, 8x, 12x, 16x)

I 17:01:11 Destination Media Sectors: 2,298,496

I 17:01:11 Write Mode: DVD

I 17:01:11 Write Type: DAO

I 17:01:11 Write Speed: 4x

I 17:01:11 Link Size: Auto

I 17:01:11 Lock Volume: Yes

I 17:01:11 Test Mode: No

I 17:01:11 OPC: No

I 17:01:11 BURN-Proof: Enabled

W 17:01:12 Write Speed Miscompare! - Wanted: 5,540 KB/s (4x), Got: 8,310 KB/s (6x)

I 17:01:12 Filling Buffer... (40 MB)

I 17:01:13 Writing LeadIn...

I 17:01:49 Writing Session 1 of 1... (1 Track, LBA: 0 - 2294911)

I 17:01:49 Writing Track 1 of 1... (MODE1/2048, LBA: 0 - 2294911)

I 17:11:07 Synchronising Cache...

I 17:11:29 Exporting Graph Data...

 

 

are burning speeds hard coded in the firmware? this same disk i was able to burn at 4x on the pio 116D

 

thanks

Edited by yikes
Link to comment
Share on other sites

 Share

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.