Jump to content
Sign in to follow this  
TWDesigns

Auto Eject after Read Errors I/O with Acronova

Recommended Posts

I found a previous topic labeled "Auto Eject after Read Errors" and it is exactly the issue I have as well. The solution was to try and check the Auto Abort on errors. I have had that already selected and am looking to see if there is something else I am missing. 

I have a Nimbie and everything works perfect up until I get an I/O disk error and then it stops and asks me to Retry, Cancel and Stop (maybe, I don't remember exactly). I am looking for the system to abort on I/O errors.

Any suggestions are appreciated.

PS I have the Auto Loader Selected along with Acornova and the box for Auto Abort checked.

Share this post


Link to post
Share on other sites
Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use.