pedrofdmp

My board is set to AHCI ICH9 is not supported only ICH9R, ICH9M etc... you can check it here: http://downloadmirror.intel.com/17412/eng/readme.txt and here: http://en.wikipedia.org/wiki/I/O_Controller_Hub#ICH9 Intel does not officialy support ahci on ich9 You really have to force the driver for it to install. And i'm back to the latest version of imgburn

Matrix driver does not detect ich9, only ich9r had to extract it and force instalation also instaled jmicron drivers for the second controler (only have a lg ide drive there) i will do a couple more burns and see how it turns out i'm also using 2.4.2.0 for precaution <- good idea ? ahci is faster i supose... as for ich9 i wish i got ich9r instead, less issues with forcing drivers

It's using ICH9 AHCI mode, this has happened without the intel chipset drivers and now that i have installed them it persists. btw i just noticed this thread: http://forum.imgburn.com/index.php?showtopic=8327 should i also install the "matrix" stuff besides the chipset drivers ?!

Since i upgraded to vista ultimate x64 from windows xp x64 i've been having problems with imgburn This is random, i can burn a couple of discs and then the problem pops up It stops burning and speed goes to 0.0x and just stays there, if i try to abort nothing happens and i can't open the drive, i have to reboot. Reboot takes a long time, i usualy just have to hit the reset buton This has happened with dvd+r dl, cd-r , dvd-r ... I 02:58:11 ImgBurn Version 2.4.4.0 started! I 02:58:11 Microsoft Windows Vista Ultimate x64 Edition (6.0, Build 6001 : Service Pack 1) I 02:58:11 Total Physical Memory: 8.386.128 KB - Available: 6.871.852 KB I 02:58:11 Initialising SPTI... I 02:58:11 Searching for SCSI / ATAPI devices... I 02:58:22 Found 1 DVD

yes i have auto change book enable, didn't notice thank you for your help Do you have Auto 'Change Book Type' enabled? http://forum.imgburn.com/index.php?s=&...ost&p=65050

I have two burners LiteOn LH-20A1P and LG GSA-H42L and i have the same problem with both imgburn always sets the bit setting to dvd-rom even though i preset it at dvd+r is this normal?