Folks,
First of all thanks for the Program. I finally moved off of Nero as it got far too bloated => like my previous standard Roxio did some years before.
I'm relatively new to ImgBurn but not a complete novice. I stumbled across ImgBurn when investigating how to back up my BluRay Movies onto BD-Rs, so I wouldn't have to worry about them getting damaged at the Cabin when the kids use them. I found ClownBD, a useful interface (program) that does back up BluRay movies using ImgBurn(but unfortunately lacks the ability to keep the Menus.) I used a previous version of ImgBrn when doing that some months ago which worked flawlessly to Burn my Verbatim LTH BD-Rs at 10X, but now have installed Version 2.5.2.0. which I can't get it to burn above the nominally rated 2X. (I've tried on 3 disks. I modified Automatic Speed Write. But it's still a 80 minute cycle to Burn / Verify a Data disk. (I'm backing up my Tunes in case of a Hard Drive Failure.)
The Destination Device is my HL-DT-ST BD-RE BH10LS30 with Firmware 1.00. (I know there is some 1.00-06 and 1.00-07 firmware out there, but I can't find it on an "official" LG Site so I'm hesitant to install them. I know, don't be so paranoid...)
W 08:57:38 Write Speed Miscompare! - Wanted: 44,956 KB/s (10x), Got: 8,991 KB/s (2x)
My Box has enough horsepower (Quad Intel Processor, 4 Gigs Ram, etc.,) and it Burned at 10X in an earlier version of ImgBurn so I'm thinking there must a setting I'm missing of a ?
Please advise if you can help out. (I upped my Log File.)
Thanks for the assist.
Regards,
Jim
ImgBurn.log
