I saved a trial download of Microsoft Visual Studio 2005 to my hard drive; it has an ".img" extension. My goal is to burn it to DVD, so that I may open the files in the download from the burned DVD and execute "SETUP.EXE".
When I used ImgBurn to burn it to a Fujifilm DVD-R disc, there was an error during verification. Thinking there was a scratch or something on the DVD causing the problem, I tried it again with another disk....same error. Then I searched through the forum trying to find an answer. One topic I read suggested speed of writing could cause a problem, so I tried again, selecting "4X" rather than "AUTO." The same error occurred again. All three times, though, when I clicked the CONTINUE button available in the I/O ERROR dialog, it finished with "Operation Successfully completed." I don't know what to think, especially since the log indicates the error is in the setup.exe file....if I use the DVD to install the download, will it complete successfully? Or perhaps someone can tell me how I can eliminate this error?
Details:
PRE-BURN INFO ABOUT THE DVD TO BE USED:
HL-DT-ST DVD+-RW GSA-H21N A105 (ATA)
Current Profile: DVD-R
Disc Information:
Status: Empty
Erasable: No
Free Sectors: 2,297,888
Free Space: 4,706,074,624 bytes
Free Time: 510:40:38 (MM:SS:FF)
Supported Write Speeds: 4x, 8x
Pre-recorded Information:
Manufacturer ID: ProdiscF01
Recording Management Area Information:
HL-DT-ST DVD+-RW GSA-H21N
FROM THE I/O ERROR DIALOG DURING VERIFICATION:
I/O Error!
Device:
ScsiStatus: 0x02
Interpretation Check Condition
CDB: 28 00 00 10 00 00 00 00 01 00
Interpretation: Read(10) - Sector: 1048576
Sense Area: 70 00 05 00 00 00 00 0E 00 00 00 00 64 00 00 00 00 00
Interpretation: Illegal Mode For This Track
CANCEL TRY AGAIN CONTINUE
FROM THE LOG:
Sector 1048576 maps to file: vs\wcu\SDK\x64\setup.exe
ANY INSIGHT WOULD BE MOST APPRECIATED AND THANK YOU!!!
