Jump to content

bephipps

Members
  • Posts

    6
  • Joined

  • Last visited

bephipps's Achievements

ISF Newbie

ISF Newbie (1/5)

  1. I have burned a ton of stuff using this program but I can't remember seeing this before. After I set everything up and it gos to the burning page at the bottom it says Locking Volume for Exclusive access and it just sits there. Any help would greatly be appreciated.
  2. Thanks I'll try that
  3. No, what speed should I start with?
  4. Still kinda new at this so forgive me. This has been an off and on problem. Sometimes I can copy a disc and not have a problem and sometimes when I run verify it fails to read sectors. I changed discs, now using verbatim. I updated my firmware for my burner. Not sure where to go from here. My burner TSST Corp CD/DVDW TS-H652L.I Have attatched my most recent log. Any help would be appreciated. ImgBurn.log
  5. Please help!! This has been an off and on problem. I have change the type of discs a couple of times. That worked for a while. Do I have something set up wrong or configured wrong. Thanks for any help or suggestionsImgBurn.log
  6. I have been using imgburn without a problem for a few months. Here lately about every other disc I burn is messed up. It burns the disc and then it stops and starts burning again leaving a huge gap on my disk. Not sure if it's my burner or what. Please help
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.