Failed to Write Sectors... Reason: Invalid Address For Write

[semperego]

VER 2.5 FAILS TO WRITE ISO TO DVDs. IS THIS A BUG IN VER 2.5? IMGBURN.LOG ATTACHED. TRIED 4 TIMES AND FAILED 4 TIMES. WROTE ISO WITH ULTRA ISO AND IMAGE RECODER ON SAME COMPUTER SAME DRIVE SAME DISKS WITH NO PROBLEMS WHATSOEVER. COULD IT BE BECAUSE PortableMode=1???

[mmalves]

There's no log attached

[semperego]

There's no log attached

I just did. Not sure why it did not upload the first time

ImgBurn.log

[mmalves]

It seems the controller where the drive is connected to is messing up the communication. Try using the Incremental write type (Tools -> Settings -> Write tab). You may also want to try another SATA cable and other SATA ports.

 

I 15:55:54 Destination Device: [2:1:0] ATAPI iHAS324 A BL17 (W:) (ATA)

There's newer firmware available for your burner (remove any disc and close the tray before updating then reboot after it's finished).

[semperego]

It seems the controller where the drive is connected to is messing up the communication. Try using the Incremental write type (Tools -> Settings -> Write tab). You may also want to try another SATA cable and other SATA ports.

 

I 15:55:54 Destination Device: [2:1:0] ATAPI iHAS324 A BL17 (W:) (ATA)

There's newer firmware available for your burner (remove any disc and close the tray before updating then reboot after it's finished).

 

OK, thank you for the information. I will give it a try.