xfile102 Posted August 14, 2009 Share Posted August 14, 2009 I 16:22:23 ImgBurn Version 2.5.0.0 started! I 16:22:23 Microsoft Windows Vista Ultimate x64 Edition (6.0, Build 6000) I 16:22:23 Total Physical Memory: 4,192,960 KB - Available: 2,426,740 KB W 16:22:24 I/O Interface 'Debug Mode' Enabled! I 16:22:24 Initialising SPTI... I 16:22:24 Searching for SCSI / ATAPI devices... I 16:22:24 Initialising Device (\\?\scsi#cdrom&ven_atapi&prod_ihas120___6#5&6415ed4&0&000000#{53f56308-b6bf-11d0-94f2-00a0c91efb8b})... I 16:22:24 Device Address: [4:0:0] I 16:22:24 Drive Letter: (I:) I 16:22:24 Device Maximum Transfer Length: 65,536 I 16:22:24 Device Maximum Physical Pages: 17 I 16:22:24 Device Alignment Mask: 1 I 16:22:24 Device Bus Type (Adapter/Device): RAID / RAID I 16:22:24 [4:0:0] (I:) (RAID) I 16:22:24 CDB: 12 00 00 00 60 00 I 16:22:24 CDB Interpretation: Inquiry *** As a note, your site says this error is caused by OLD drives, My drive is actually one of the newest and most common DL Burners on the market. Link to comment Share on other sites More sharing options...
mmalves Posted August 14, 2009 Share Posted August 14, 2009 Your SATA controller is in RAID mode and that's probably what's blocking the commands. Do you need to have it in RAID mode? It would be best if you could use AHCI mode. You should also install Service Pack 2 on your Windows Vista Link to comment Share on other sites More sharing options...
xfile102 Posted August 14, 2009 Author Share Posted August 14, 2009 No, I do not need it in RAID mode, But I do not know how to get it out of Raid. Link to comment Share on other sites More sharing options...
mmalves Posted August 15, 2009 Share Posted August 15, 2009 The option to change the mode is in the BIOS, which you can usually access by pressing DEL/F10/maybe other key(s) at the boot screen. Link to comment Share on other sites More sharing options...
Recommended Posts