Jump to content

Power Calibration Area Error


GoofyNut

Recommended Posts

I followed all instructions to the letter but still can't get this done!! I've tried 3 times and

I have no idea where I've gone wrong. Hopefully, someone, anyone, will be able to look

at the following log and figure it out.

 

I have a Slimtype DVDRW SOSW-833S drive and am using Verbattim DVD+R DISCS.

 

THANKS!!!

 

 

I 03:16:49 ImgBurn Version 2.5.0.0 started!

I 03:16:49 Microsoft Windows XP Home Edition (5.1, Build 2600 : Service Pack 3)

I 03:16:49 Total Physical Memory: 1,964,528 KB - Available: 1,193,660 KB

W 03:16:49 Drive C:\ (FAT32) does not support single files > 4 GB in size.

W 03:16:49 Drive D:\ (FAT32) does not support single files > 4 GB in size.

I 03:16:49 Initialising SPTI...

I 03:16:49 Searching for SCSI / ATAPI devices...

I 03:16:49 Found 1 DVD

Link to comment
Share on other sites

1. Look at

 

THIS

 

about your burner.

 

2. I would switch over to a full sized drive in an external enclosure and run it off of the USB port to get away from all the 'slimline' problems that we see here every day.

 

3. You can also try different speeds for the burn.

 

(Speeds: 2.4x, 4x, 6x, 8x)

 

4. Look for an update to your firmware.

 

VRS3

 

5. Sounds like quite a hacker flick...

TRAILER_PARK_OF_TERROR

 

=))=))

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.