gryffin Posted May 9, 2006 Share Posted May 9, 2006 Thanks LUK for a great product. I'm using DVD Rebuilder in a mode that calls Imgburn to burn the image created after the "rebuild" automatically, to blank media resident in the burning drive. I am using 16x media, but do not get reliable burns at that speed. Is there a way to set up Imgburn in a way that, when called by DVD Rebuilder, it will not burn at max but instead at a selected lower speed (in my case, 12x)? In other words, can I set up Imgburn in advance to retain a burn speed setting that will apply when DVD Rebuilder calls it? Link to comment Share on other sites More sharing options...
cornholio7 Posted May 9, 2006 Share Posted May 9, 2006 could you please try something? open imgburn and set your burning speed to 12x , close the programme and open it again , what burn speed does it show? i know when i open the programme it stays at the last selected speed Link to comment Share on other sites More sharing options...
lfcrule1972 Posted May 9, 2006 Share Posted May 9, 2006 It does for me too corn ! Link to comment Share on other sites More sharing options...
gryffin Posted May 10, 2006 Author Share Posted May 10, 2006 Thanks. I hadn't noticed. I'll give it a try. Link to comment Share on other sites More sharing options...
polopony Posted May 10, 2006 Share Posted May 10, 2006 yep IMGburn will stay at the selected speed BUT the drive has to have a firmware that will support writing at the selected speed and the media has to support the speed also if any of these dont apply then it will revert to a speed thats supported automatically ,hope this makes sense Link to comment Share on other sites More sharing options...
Recommended Posts