Retaining A Selected Burn Speed Setting

[gryffin]

Thanks LUK for a great product.

 

I'm using DVD Rebuilder in a mode that calls Imgburn to burn the image created after the "rebuild" automatically, to blank media resident in the burning drive. I am using 16x media, but do not get reliable burns at that speed. Is there a way to set up Imgburn in a way that, when called by DVD Rebuilder, it will not burn at max but instead at a selected lower speed (in my case, 12x)? In other words, can I set up Imgburn in advance to retain a burn speed setting that will apply when DVD Rebuilder calls it?

[cornholio7]

could you please try something?

open imgburn and set your burning speed to 12x , close the programme and open it again , what burn speed does it show?

i know when i open the programme it stays at the last selected speed

[lfcrule1972]

It does for me too corn !

[gryffin]

Thanks. I hadn't noticed. I'll give it a try.

[polopony]

yep IMGburn will stay at the selected speed BUT the drive has to have a firmware that will support writing at the selected speed and the media has to support the speed also if any of these dont apply then it will revert to a speed thats supported automatically ,hope this makes sense