Dissemble Posted March 24, 2010 Share Posted March 24, 2010 (edited) Hardware needed: Nimbie NB11 (PC Connected) Please follow the procedures below - 1.ImgBurn Software Installation a. Go the ImgBurn website - http://www.imgburn.com/index.php?act=download b. Pick up equivalent version v2.5.1.0 or above for downloading 2.Downloading the file: DLLv21032forImgBurn.zip a. See the attachment and please download the attachment of DLLv21032forImgBurn.zip b. Download DLLv21032forImgBurn.zip to ImgBurn Folder which locates and normally defaults to C:\Program Files\ImgBurn 3.Turn the Nimbie NB11 on and connect it to PC. Make sure the ready signal light of Nimbie NB11 is flashing. 4.Run ImgBurn Burning Software. 5.Choose the functions of “Tools” and then pick up “Settings”. 6.Under the functions of “Settings”, go to “I/O” and check “Auto Loaders” which is under Enumerate Devices functions and press OK. 7.Nimbie NB11 will start the initializing process and please wait for about couple Minutes. After being initialized, the functions of the Imgburn will be enabled. 8.Reminder – Please pick up the RW that provided by Nimbie NB11 as the destination. DLLv21032forImgBurn.zip Edited March 24, 2010 by Dissemble Link to comment Share on other sites More sharing options...
LIGHTNING UK! Posted March 24, 2010 Share Posted March 24, 2010 I hope you don't mind but I've done a proper one with pictures here: http://forum.imgburn.com/index.php?showtopic=14158 Link to comment Share on other sites More sharing options...
Dissemble Posted March 25, 2010 Author Share Posted March 25, 2010 I hope you don't mind but I've done a proper one with pictures here: http://forum.imgburn.com/index.php?showtopic=14158 Thank you very much! Link to comment Share on other sites More sharing options...
Recommended Posts