Jump to content

How to create a double layer DVD Video image file using ImgBurn


cornholio7

Recommended Posts

This will cover making a Dual Layer ISO on your Hard Drive.

 

Firstly make sure your Vob, Ifo and Bup files are in a folder called VIDEO_TS

 

then open ImgBurn in Build Mode and choose the folder option in the source box, and navigate to the folder you stored the files.

 

post-8-1150222047_thumb.png

 

post-8-1153590782_thumb.png

 

When you have chosen the folder you require it should look like the picture above.

 

post-8-1153590828_thumb.png

 

Then press the Calculator and you will see a similar window to this, where you should choose the layer break.

 

post-8-1151419497_thumb.png

 

The best option here is the one on the right that says 'No' in the SPLIP column. Then press 'Ok'.

The Legend at the bottom also indicates the best choices.

 

At this point go to the options tab, choose ISO9660+UDF

 

post-8-1153590997_thumb.png

 

Next go to Labels and enter the name of your ISO in both fields.

 

post-8-1153591129_thumb.png

 

Next go to Advanced -> Media and ensure you have selected the appropriate profiles for the media you're intending to write to.

 

If the estimated size of the image exceeds that specified in the 'Single Layer' -> 'Maximum Sectors' box, the program will know you're building a double layer ISO and configure itself accordingly. This is where the 'Double Layer' profile then comes in.

 

If you do not select the correct profile you may have problems with the layer break when you burn the ISO file.

 

post-1-1156350951_thumb.png

 

Next choose your destination, and press the Build Button (Highlighted in the red box).

 

The Layer Break choice window will appear again at this point.

 

post-8-1153837714_thumb.png

 

Normally you shouldn't worry about ticking the 'Don't update IFO/BUP files' box, and you should definintely not tick it unless you have prepared IFO's in advance containing layer break info.

 

Press 'Ok'.

 

You will then see this window.

 

post-8-1153591197_thumb.png

 

Press 'Ok' and the programme will start building.

 

post-8-1150347025_thumb.png

 

Then just wait a few minutes (system dependent) and your ISO and MDS will be ready.

 

post-8-1150347051_thumb.png

 

Remember to choose the MDS file when you eventually burn this ISO as it contains the layer break information.

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.