Jump to content

Why won't it eject after Verify?


JohnnyBob

Recommended Posts

It used to, but quit after I recently reinstalled my op system and ImgBurn. I guess I may not have a setting right somewhere.

 

My usual procedure is to burn a disc (Write files/folders to disc) including an automatic verify thereafter, then I want it to eject the finished product. It cycles the tray after burning, before the verify, so it recogized the drive OK. Why won't it eject the tray after the verify?

 

I note that there is no eject option on the Settings > Verify tab. However on the Device tab, there are checkboxes to eject after a Read, Write, Verify, or Erase operation, and I have the Verify box checked there. What/where else would the proper setting be located?

Link to comment
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.