holygamer Posted January 14, 2012 Posted January 14, 2012 (edited) I backup my data quite often. Burning 1 disc at a time is time consuming so I would like to burn at least 2 separate images to 2 Bluray discs at the same time. So I would have 2 instances of ImgBurn open at the same time. Is this possible? If so, what is the maximum amount of Bluray discs I could burn at once at the full speed (4x) of my media if the ISO's are being read from a USB 2.0 drive? What about if I used a USB 3.0 drive? Edited January 14, 2012 by holygamer
LIGHTNING UK! Posted January 14, 2012 Posted January 14, 2012 You'd only manage 1 at a time from a usb 2 drive. They usually max out at around 25-30mb/s. With usb 3 and a decent hdd you might manage 4... but with that many non sequential reads you'd kill the actual transfer rate end up being better off with 2 or 3.
mmalves Posted January 14, 2012 Posted January 14, 2012 What about if I used a USB 3.0 drive? Another option would be eSATA, if your system / external HDDs have them.
holygamer Posted September 30, 2012 Author Posted September 30, 2012 (edited) I would like to have 4 instances of ImgBurn open and burn 4 seperate images from a single USB 3.0 Hard Drive onto 4 Bluray Discs at the same time. I currently burn at 4x. Would I need a special motherboard with SATA III to do that or has that got nothing to do with burning discs from a USB 3.0 Hard Drive? Edited September 30, 2012 by holygamer
LIGHTNING UK! Posted September 30, 2012 Posted September 30, 2012 SATA 1 (150) is more than enough for any speed burning on optical discs. As I said before, even if USB 3.0 could cope with the I/O requests, you're likely to run into issues with the random accessing on a single drive. I think 70MB/s would be asking too much...but you might get lucky!
holygamer Posted August 15, 2013 Author Posted August 15, 2013 (edited) OK instead of USB 3.0 I just dismantled the drive and put the actual hard drive inside my PC as a SATA III hard drive. My motherboard supports SATA III. Some Bluray ISOs are on the drive. I'm trying to burn 2 different images from that hard drive onto 2 discs at the same time so I have 2 instances of ImgBurn open. At random ImgBurn is burning both discs at 1x instead of 4x. I could be burning at the correct speed for days then at random it burns at 1x. Why would that happen? I'm not doing anything else on my PC apart from burning those discs yet it's burning at 1x. Yet most of the time when I AM doing other things I can get 4x! My PC is working fine and I've got all drivers and firmware installed correctly. I was also wondering how the verify is going to 4.6x when I set the AWS speed to 4x? Edited August 15, 2013 by holygamer
Recommended Posts