Jump to content

Recommended Posts

Posted (edited)

I wrote a Win2K8 iso to a DVD+R a bit ago and it failed to boot (though ImgBurn says the burn was successful). I was also unable to open the DVD post-burn on a Win7 machine. The ISO is good, I mounted it with CloneDVD without issues. The PC (which I am running ImgBurn on) is a Win7 SP1, DELL Dimension 5150.

 

So, I tried a DVD-R (just in case - actually more than one, just to be sure). The drive would not initialize the disc. So I restarted and then decided to upgraded the firmware on my DVD/RW drive, after which I recieved the error below. So, I upgraded ImgBurn from 2.5.5.0 to 2.5.6.0. And I am still getting this same error.

 

The Log should be attached. As well as a screen shot of the GUI error which reads:

I/O Error!

 

Device: [0:0:0] HL-DT-ST DVD+-RW GSA-H21N B109 (D:) (ATA)

 

ScsiStatus: 0x02

Interpretation: Check Condition

 

CDB: 2A 00 00 00 00 00 00 00 20 00

Interpretation: Write (10) - Sectors: 0 - 31

Sense Area: 70 00 03 00 00 00 00 0E 00 00 00 00 0C 80 00 00 00 00

Interpretation: Unknown (Write Error) (ASC: 0x0C, ASCQ: 0x80)

2-22-2012 12-50-13 PM.bmp

ImgBurn.log

Edited by David Wall VA Fairfax

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.